Whirlpool TES325MQ2 manual Troubleshooting

To Replace:

1.Lift up the back of the drawer and place it inside the range in its fully forward position.

2.Lift up the front of the drawer to a level position.

3.Slowly push the drawer into the range until the drawer side rails engage with the gap in the drawer glides.

A

4.Once the drawer is fully engaged on both sides, slide the drawer back into the closed position.

NOTE: When removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides.

A. Engage drawer glide

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

■Is the power supply cord unplugged? Plug into a grounded outlet.

■Has a household fuse blown, or has a circuit breaker tripped?

Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician

Cooktop will not operate

■Is the control knob set correctly? Push in knob before turning to a setting.

■On ceramic glass models, is the “Control Lock” set? See “Control Lock” section.

Excessive heat around cookware on cooktop

■Is the cookware the proper size?

Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.

Hot Surface indicator light stays on

■Does the Hot Surface indicator light stay on after control knob(s) have been turned off?

See “Cooktop Controls” section.

Cooktop cooking results not what expected

■Is the proper cookware being used? See “Cookware” section.

■Is the control knob set to the proper heat level? See “Cooktop Controls” section.

■Is the appliance level?

Level the appliance. See the Installation Instructions.

Oven will not operate

■Is the electronic oven control set correctly? See “Electronic Oven Control” section.

■Has a delay start been set? See “Timed Cooking” section.

■On some models, is the Control Lock set? See “Control Lock” section.

Oven temperature too high or too low

■Does the oven temperature calibration need adjustment? See “Oven Temperature Control” section.

■On some models, does the cooling fan run during BAKE, BROIL or CLEAN?

It is normal for the fan to automatically run when the oven is in use. This helps cool the electronic control.

Oven indicator lights flash

■Do the oven indicator lights flash?

See the “Display” and/or the “Oven Indicator Lights” section. If the indicator light(s) keeps flashing, call for service. See “Assistance or Service” section.

Display shows messages

■Is the display showing “PF” or a flashing time? There has been a power failure. Clear the display. See “Display(s)” section. On some models, reset the clock, if needed. See “Clock” section.

■Is the display showing a letter followed by a number? Depending on your model, press OFF/CANCEL, OFF or CANCEL/OFF to clear the display. See “Display(s)” section. If it reappears, call for service. See “Assistance or Service” section.

18