5.Attach the cold water hose to the top inlet valve.
6.Screw on coupling by hand until it is seated on the washer.
7.Using pliers, tighten the couplings with an additional
NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result.
Check for leaks
Turn on the water faucets and check for leaks. A small amount of water might enter the washer. You will drain this later.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates for future reference.
■If you connect only one water hose, you must cap off the remaining water inlet port.
■Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.
Secure the Drain Hose
1.Remove the shipping strap from the power cord. Drape the power cord over the console.
2.Remove any cardboard used to move washer.
Beaded tie strap
3.Wrap the drain hose to the laundry tub leg or drain standpipe with the beaded tie strap. Push fastener into the nearest hole in the beaded tie strap. See view A or B.
ABC
If the washer faucets and the drain standpipe are recessed, put the formed end of the drain hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the drain hose. See view C.
Level the Washer
Properly leveling your washer avoids excessive noise and vibration.
Install the Front Leveling Feet
1.Prop up the front of the washer about 10.2 cm (4") with a wood block or similar object. The block needs to support the weight of the washer.
10.2 cm (4")
A
A. Threaded holes for feet
2.Screw the locknut onto each foot to within 2.5 cm (1") of the foot base.
2.5 cm
(1")
3.Screw the feet into the threaded holes at the front corner of the washer until the nuts touch the washer. Twist the feet to install.
NOTE: Do not tighten the nuts until the washer is level.
4.Tilt the washer back and remove the wood block. Gently lower the washer to the floor.
7
