INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. The parts supplied are in the washer basket.
Tools needed for connecting the drain hose and water inlet hoses:
■ Pliers that open to | ■ Flashlight (optional) |
3.95 cm (1⁹⁄₁₆") |
|
Parts supplied:
ABC
A. Drain hose form
B. Water inlet hoses (2)
C. Flat water inlet hose washers (4)
Tools needed for securing the drain hose and leveling the washer:
■ | Adjustable or open end | ■ | Wood block |
| wrench 14 mm (⁹⁄₁₆") | ■ | Ruler or measuring tape |
| Level | ||
■ |
|
|
Parts supplied:
AB
A. Beaded tie strap
B. Front leveling feet with nuts (2)
Alternate Parts
Your installation may require additional parts. For information on ordering, please refer to the
If You Have: | You Will Need to Buy: |
|
|
Laundry tub or | Sump pump system (if not already |
standpipe taller | available) |
than 2.4 m (96") |
|
|
|
2.5 cm (1") | 3.2 cm (1¹⁄₄") diameter to 2.5 cm (1") |
diameter | diameter standpipe adapter, |
standpipe | Part Number 280130 |
|
|
Overhead sewer | Standard 76 L (20 gal.) 99 cm (39") tall |
| drain tub or utility sink, sump pump and |
| connectors (available from local |
| plumbing suppliers) |
|
|
Floor drain | Siphon break, Part Number 280129; |
| additional drain hose, |
| Part Number 3357090 |
|
|
Water faucets | 2 longer water fill hoses: |
beyond reach of fill | 1.8 m (6 ft) Part Number 76314, |
hoses | 3.0 m (10 ft) Part Number 350008 |
|
|
Drain hose too | Drain hose kit, Part Number 280131 |
short |
|
|
|
Lint clogged drain | Drain protector, Part Number 367031 |
Location Requirements
Selecting the proper location for your washer improves performance and minimizes noise and possible washer “walk.”
Your washer can be installed in a basement, laundry room, closet, or recessed area. See “Drain System.”
IMPORTANT: Do not install or store the washer where it will be exposed to the weather.
Proper installation is your responsibility.
You will need:
■A water heater set to deliver 49°C (120°F) water to the washer.
■An earthed electrical outlet located within 1.2 m (4 ft) of where the power cord is attached to the back of the washer. See “Electrical Requirements.”
■Hot and cold water faucets located within 90 cm (3 ft) of the hot and cold water fill valves, and water pressure of 34.5-
690 kPa
■A level floor with a maximum slope of 2.5 cm (1") under entire washer. Installing the washer on carpeting is not recommended. Ventilation openings in the base must not be obstructed by carpet.
■A sturdy floor to support the washer weight (washer, water and load) of 143 kg (315 lbs).
Do not store or operate your washer in temperatures at or below 0°C (32°F). Some water can remain in the washer and can cause damage in low temperatures. See “Washer Care” in the Washer User Instructions for winterizing information.
2
