End of Cycle Signal
The End of Cycle Signal produces an audible sound when the drying cycle is finished. Promptly removing clothes at the end of the cycle reduces wrinkling.
Press and release the END OF CYCLE SIGNAL to adjust the sound level or turn off the signal.
Hold the END OF CYCLE SIGNAL for 3 seconds to lock or unlock this control.
NOTE: When the WRINKLE SHIELD™ feature is selected and the End of Cycle Signal is on, an audible sound will be emitted every 5 minutes until the clothes are removed, or the WRINKLE SHIELD™ feature is finished.
Changing Cycles, Options and Modifiers
You can change Auto Cycles, Timed Cycles, Modifiers and Options anytime before pressing Start.
■Three short tones sound if an unavailable combination is selected. The last selection will not be accepted.
Changing Cycles after pressing Start
1.Press STOP twice. This ends the current cycle.
2.Select the desired cycle and options.
3.Press and hold START. The dryer starts at the beginning of the new cycle.
NOTE: If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off.
Changing Modifiers and Options after pressing Start
You can change a Modifier or Option anytime before the selected Modifier or Option begins.
1.Press STOP once.
2.Select the new Modifier and/or Option.
3.Press and hold START to continue the cycle.
NOTE: If you happen to press Stop twice, the program clears and your dryer shuts down. Restart the selection process.
Drying Rack Option
Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move.
If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for more information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer.
NOTE: The rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack.
To use the drying rack
Do not remove the lint screen.
1.Open dryer door.
A
A. Front edge
2.Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure over the lint screen.
B 
A
A. Dryer rack front edge
B. Dryer back panel
3.Put the wet items on top of the rack. Leave space between the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the rack.
4.Close the door.
5.Press the POWER button.
6.Select a timed drying cycle and temperature (see following chart). Items containing foam, rubber or plastic must be dried on a clothesline or by using the Air Only temperature setting.
7.You must select a time by pressing TIMING Up or Down. Reset time as needed to complete drying. Refer to the following table.
8.Press (and hold) START button (about 1 second).
This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold.
Rack Dry | Setting | Temp. | Time* |
Wool Sweaters | Timed | Low | 60 |
Block to shape and lay flat on | Dry |
|
|
|
|
| |
the rack. |
|
|
|
|
|
|
|
Stuffed toys or pillows | Timed | Low | 60 |
Cotton or polyester fiber filled | Dry |
|
|
|
|
| |
|
|
|
|
Stuffed toys or pillows | Timed | Air Only | 90 |
Foam rubber filled | Dry | (no heat) |
|
|
| ||
|
|
|
|
Sneakers or canvas shoes | Timed | Air Only | 90 |
| Dry | (no heat) |
|
|
|
| |
|
|
|
|
*(Minutes) Reset time to complete drying, if needed.
23
