20
W10115226C
W10115227C-SP
© 2012 Whirlpool Corporation 02/12
All rights reserved Printed in U.S.A.
Remove and transfer plugs
11.
Remove the 4 screws that attach 2 plugs on the left side.
Transfer plugs to opposite side using the same 4 screws.
Attach door hinges
9.
Reattach door hinges to dryer door so that the larger hole is
at the bottom of the hinge.
Check door strike alignment
14.
Close door and check that door strike aligns with door catch.
If it is needed, slide door catch left or right within slot to
adjust alignment.
Troubleshooting
See the Use and Care Guide or visit our website and
reference “Frequently Asked Questions” to possibly avoid
the cost of a service call.
NOTE: 2 people may be needed to reinstall door.
Insert screws into the bottom holes on left side of dryer cabinet.
Tighten screws halfway. Position door so large end of door hinge
slot is over screws. Slide door up so screws are in bottom of
slots. Tighten screws. Insert and tighten top screws in hinges.
Rotate outer door
8.
Take outer door and rotate it 180º and set it back down on
inner door. Be certain to keep cardboard spacer centered
between doors. Reattach outer door panel to inner door
panel so handle is on the side where hinges were just
removed. Insert 4 door screws.
Remove door strike from dryer cabinet and set aside.
Remove door strike
10.
Remove door strike plug. Insert the door strike removed in
Step 10 into hole and secure with screw. Insert door strike
plug into original door strike hole and secure with screw.