Whirlpool W10115226C, W10115227C-SP INSTALL LEVELING LEGS

INSTALL LEVELING LEGS

Prepare dryer for leveling legs

To avoid damaging oor, use a large at piece of cardboard

from dryer carton; place under entire back edge of dryer.

Firmly grasp dryer body (not console panel) and gently lay

dryer down on cardboard.

Screw in leveling legs

diamond

marking

Examine leveling legs and nd diamond marking. Screw legs

into leg holes by hand. Use a wrench to nish turning legs

until diamond marking is no longer visible.

Now stand the dryer on its feet. Slide the dryer until it is

close to its nal location. Leave enough room for electrical

connection and to connect the exhaust vent.

Contents

Main W10115226C W10115227C-SP ELECTRIC DRYER INSTALLATION INSTRUCTIONS 27" WIDE MODELS - U.S.A. ONLY Table of Contents Page INSTALLATION REQUIREMENTS Tools and Parts Tools needed: Parts needed: Location Requirements Electrical Requirements It is your responsibility: Electrical Connection If your outlet looks like this: INSTALL LEVELING LEGS Screw in leveling legs Prepare dryer for leveling legs ELECTRICAL CONNECTION Electrical Connection Options 1. NOTE: 2. A strain relief Power supply cord strain relief 4-Wire Power Supply Cord Connection E 3. Connect remaining wires 2. 1. 3. 4-Wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile direct connection relief 2. ground wire and neutral wire E B 1. 2. Direct wire strain relief 1. Direct Wire Connection 3-Wire Direct Wire Connection 2. 4. 5. 3. direct connection 1. ground wire and neutral wire Connect neutral ground wire 3. Connect external ground wire VENTING Recommended Styles: Plan Vent System Optional exhaust installations: Alternate installations for close clearances Venting Kits Install Vent System Install exhaust hood Connect vent to exhaust outlet Connect vent to exhaust hood Vent System Chart Level Dryer Move dryer to nal location Level Dryer Tighten and adjust leveling legs Complete Installation Checklist q DOOR REVERSAL Reverse Door Swing (Optional) Remove screws from hinges 3. Rotate outer door Page Page Remove and transfer plugs W10115226C W10115227C-SP 11. Remove door strike plug Rotate outer door 13. 10.