NOTE: Reinstall one of the screws through the range cooktop to hold the orifice spud holder in place while removing and replacing the orifice spuds.
C
A
D
B 
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
3.Apply masking tape to the end of a ⁵⁄₁₆" nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside.
C
A
D
B
A.Orifice spud
B.Orifice spud holder
C.Screw
D.Spark electrode
4.Remove the cardboard orifice spud holder located on the back of the range near the gas inlet. Gas orifice spuds are stamped with a number, marked with 1 color dot, and have a groove in the hex area. Replace the Natural gas orifice spud with the correct LP gas orifice spud.
A
A. Groove
Refer to the following chart for correct LP gas orifice spud placement.
LP Gas Orifice Spud Chart for Surface Burners
Burner Rating | Color | Size | ID Number |
|
|
|
|
14,000 BTU | Yellow/Orange | 1.07 mm | L107 |
11,000 BTU | Yellow/Brown | 0.99 mm | L99 |
8,000 BTU | Yellow/Black | 0.85 mm | L85 |
5,000 BTU | Yellow/White | 0.70 mm | L70 |
NOTE: Refer to the Model Number and Serial Number Plate located behind the left side of the storage or warming drawer for proper sizing of spuds for each burner location.
5.Place Natural gas orifice spuds in the cardboard orifice spud holder.
6.Replace the burner base using both screw.
7.Replace burner cap.
8.Repeat steps
To Convert Oven Bake Burner
1.Remove oven racks.
2.Use a ½" combination wrench to turn the orifice hood down snug onto pin (about 2 to 2½ turns).
IMPORTANT: Do not overtighten.
The oven bake burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Bake Burner Flame” in the “Electronic Ignition System” section.
A
B
A
A
A. Orifice hood
B. Pin
To Convert Oven Broil Burner
Use a ½" combination wrench to turn the orifice hood down snug onto the pin (about 2 to 2½ turns).
IMPORTANT: Do not overtighten.
The oven broil burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Broil Burner Flame” in the “Electronic Ignition System” section.
A 
B
A. Lock screw
B. Orifice hood
Complete Installation
1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.
2.Refer to the “Electronic Ignition System” section for proper burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
13
