Whirlpool W10196160D Replace Oven Racks and Warming Drawer, Check Operation of Oven Broil Burner

Models: W10196160D

1 32
Download 32 pages 50.24 Kb
Page 10
Image 10
Remove flame spreader:

3.You can check the burner flame by removing the flame spreader or by using a mirror.

Remove flame spreader:

Remove 2 screws from the front tabs of the flame spreader. Lift front of the flame spreader and pull forward to remove tabs from rear of oven.

Using a mirror:

Insert a mirror to one side of the burner. Look into the mirror to check flame.

A

B

C

D

A.Mirror

B.Flame spreader

C.Flame reflection

D.2 screws

4.Push the BAKE pad.

5.Press the START pad.

The oven bake burner should light within 8 seconds. Under certain conditions it may take the burner up to 50 to 60 seconds to light.

Electronic igniters are used to light the bake and broil burners.

Refer to the Use and Care Guide for proper operation of the oven controls.

Adjust Oven Bake Burner Flame (if needed)

1.On models with a warming drawer, remove access cover plate (1 screw) located at the back of the warming drawer compartment.

2.Check the oven bake burner for proper flame.

This flame should have a ½" (1.3 cm) long inner cone of bluish-green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur.

3.If the oven bake flame needs to be adjusted, locate the air shutter near the center rear of the range. Loosen the locking screw and rotate the air shutter until the proper flame appears. Tighten locking screw.

B

Using a mirror:AA

A. Air shutter

B. Locking screw

4.Push CANCEL/OFF when finished.

5.Reinstall flame spreader and oven bake burner cover.

Check Operation of Oven Broil Burner

1.Close the oven door.

2.Press the BROIL pad.

3.Press the START pad.

The oven burner should light within 8 seconds. Under certain conditions it may take the burner up to 50 to 60 seconds to light.

Refer to the Use and Care Guide for proper operation of the oven controls.

Adjust Oven Broil Burner Flame (if needed)

Look through oven window to check broil burner for proper flame. This flame should have a ½" (1.3 cm) long inner cone of bluish- green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should be present.

If flame needs to be adjusted:

1.Loosen the lock screw on the air shutter located at the rear of the broil burner.

2.Adjust the air shutter as needed.

3.Tighten lock screw.

A Adjust Oven Bake Burner Flame (if needed)

B Check Operation of Oven Broil Burner

A. Lock screw

4.Press CANCEL/OFF when finished.

Replace Oven Racks and

Warming Drawer

Replace oven racks in oven cavity. Replace warming drawer.

To Replace Warming Drawer:

1.Insert warming drawer into slide rails on sides of drawer opening.

2.Lift front of drawer slightly and push firmly to close drawer.

10

Page 10
Image 10
Whirlpool W10196160D Replace Oven Racks and Warming Drawer, Adjust Oven Bake Burner Flame if needed, Remove flame spreader