Whirlpool W10529643A - SP Non-Use,Storage, And Moving Care, Special Instructions For Steam Models

Models: W10529641A W10529643A - SP

1 40
Download 40 pages 26.89 Kb
Page 14
Image 14
NON-USE, STORAGE, AND MOVING CARE

NON-USE, STORAGE, AND MOVING CARE

Install and store your dryer where it will not freeze. Because some water may stay in the hose, freezing can damage your dryer. If storing or moving your dryer during freezing weather, winterize it.

Non-Use or Storage Care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

3.Turn off the water supply to the dryer. This helps to avoid unintended flooding (due to a water pressure surge) while you are away.

Moving Care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Gas models only: Close shut-off valve in gas supply line.

3.Gas models only: Disconnect gas supply line pipe and remove fittings attached to dryer pipe.

4.Gas models only: Cap the open fuel supply line.

5.Steam models only: Shut off water faucet.

6.Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately.

7.Make sure leveling legs are secure in dryer base.

8.Use tape to secure dryer door.

For direct-wired dryers:

1.Disconnect power.

2.Disconnect wiring.

3.Steam models only: Shut off water faucet.

4.Steam models only: Disconnect the water inlet hose from faucet; then drain the hose. Transport hose separately.

5.Make sure leveling legs are secure in dryer base.

6.Use tape to secure dryer door.

Reinstalling the Dryer

Follow the Installation Instructions to locate, level, and connect the dryer.

SPECIAL INSTRUCTIONS

FOR STEAM MODELS

Water Inlet Hose

Replace inlet hose and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hose if bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hose, record the date of replacement.

To Winterize the Dryer

1.Unplug dryer or disconnect power.

2.Shut off water faucet.

3.Disconnect water inlet hose from faucet and drain.

To Use the Dryer Again

1.Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet.

2.Plug in dryer or reconnect power as described in the Installation Instructions.

14

Page 14
Image 14
Whirlpool W10529643A - SP Non-Use,Storage, And Moving Care, Special Instructions For Steam Models, Non-Useor Storage Care