Electrical Requirements

IMPORTANT: The cooktop must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.

This cooktop is equipped with an electronic ignition system that will not operate if plugged into an outlet that is not properly polarized.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, Ohio 44131-5575

■A 120 volt, 60 Hz, AC only, 15-amp, fused electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this cooktop be provided.

■Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded.

■The wiring diagrams are provided with this cooktop. See “Wiring Diagrams” on a separate sheet. The wiring diagrams are located on the left underside of the cooktop base.

Gas Supply Requirements

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Observe all governing codes and ordinances.

IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 - latest edition or CAN/CGA B149 - latest edition.

IMPORTANT: Leak testing of the cooktop must be conducted according to the manufacturer’s instructions.

Type of Gas

Natural Gas:

This cooktop is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas.

■This cooktop is factory set for use with Natural gas. If converting to LP gas, see the “LP Gas Conversion” instructions provided in the package containing literature. The model/serial rating plate located on the underside of the cooktop base has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier.

LP Gas Conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the cooktop from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. See the Gas Conversion instructions provided in the package containing literature.

Gas Supply Line

■Provide a gas supply line of ³⁄₄" (1.9 cm) rigid pipe to the cooktop location. A smaller size pipe on longer runs may result in insufficient gas supply. Pipe-joint compounds that resist the action of LP gas must be used. Do not use TEFLON®† tape. With LP gas, piping or tubing size should be ½" minimum. Usually, LP gas suppliers determine the size and materials used in the system.

Flexible metal appliance connector:

■If local codes permit, use a ¹⁄₂" or ³⁄₄" I.D. flexible stainless steel tubing gas connector, designed by CSA to connect the cooktop to the rigid gas supply line.

■A ½" male pipe thread is needed for connection to the female pipe threads of the inlet to the cooktop pressure regulator.

■Do not kink or damage the flexible metal tubing when moving the cooktop.

Rigid pipe connection:

The rigid pipe connection requires a combination of pipe fittings to obtain an in-line connection to the cooktop. The rigid pipe must be level with the cooktop connection. All strains must be removed from the supply and fuel lines so cooktop will be level and in line.

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

5

Page 4 Page 6
Page 5
Image 5
Whirlpool W10545672A Electrical Requirements, Gas Supply Requirements, Type of Gas, Gas Supply Line
Page 4 Page 6

W10545672A specifications

The Whirlpool W10545672A is a versatile and highly efficient refrigerator that merges cutting-edge technology with functional design, catering to the needs of modern households. This appliance is renowned for its spacious interior and smart features, making it an indispensable addition to your kitchen.

One of the standout features of the W10545672A is its innovative temperature management system. Equipped with a temperature control system that ensures the optimal environment for various food types, it maintains a consistent temperature throughout the refrigerator and freezer compartments. This is crucial for food preservation, minimizing spoilage and waste.

The refrigerator comes with an adjustable shelving system that offers flexibility to accommodate taller items, such as large bottles or containers. The shelves are made from durable glass, allowing easy cleaning while providing a sturdy support structure for your groceries. The sliding shelves make it simple to access items without reaching too far back, significantly improving usability.

The W10545672A is designed with energy efficiency in mind. Its Energy Star certification signifies that it meets strict energy efficiency guidelines, making it an environmentally responsible choice. Users can enjoy reduced energy bills while helping to conserve resources.

In terms of storage solutions, the W10545672A features a variety of door bins, a crisper drawer, and specialized storage compartments. The humidity-controlled crisper drawer keeps fruits and vegetables fresh longer, while the spacious door bins can accommodate condiments and smaller items for easy access.

Additionally, the Whirlpool W10545672A includes advanced technologies such as a fingerprint-resistant finish, which keeps the exterior looking clean and sleek while reducing the appearance of smudges and fingerprints. This is particularly beneficial in busy households where the refrigerator often sees frequent use.

Another notable attribute is the LED lighting, which illuminates the fridge interior more efficiently than traditional bulbs. This not only enhances visibility but also adds to the overall energy efficiency of the unit.

Overall, the Whirlpool W10545672A stands out for its combination of spacious design, advanced temperature control, energy efficiency, and thoughtful storage solutions. Whether for a growing family or a culinary enthusiast, this refrigerator is engineered to meet a wide range of storage needs and preferences while maintaining sleek aesthetics and functionality.
Top Page Image Contents