Make Gas Connection
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
Failure to do so can result in death, explosion, or fire.
Wall oven installed below cooktop
A
B
C
D
E
F
G
H
I
J
K
Typical flexible connection
1.Apply
2.Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Tighten both adapters.
3.Use a ¹⁵⁄₁₆" combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked.
No appliance below cooktop
A
B
C
D
E
A. Manifold entrance | F. Adapter (must have ³⁄₈" male |
B. ³⁄₈" elbow | pipe thread) |
C. Use | G. Use |
D. Adapter (must have ³⁄₈" male | H. Appliance pressure regulator |
pipe thread) | (supplied) |
E. Flexible connector (pass | I. ½" or ¾" gas pipe |
through wall between | J. Manual gas shutoff valve |
cabinets) | K. ½" or ¾" gas pipe |
4.Install the pressure regulator with the arrow pointing up toward the bottom of the cooktop base and in a position where you can reach the regulator access cap.
B
A
C
D
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
F
G
H
I
A. Manifold entrance
B. Gas pressure regulator C. Use
D. Adapter (must have ½" male pipe thread)
E. Flexible connector F. Adapter
G. Use
D. Up arrow. Regulator must be installed with arrow pointing up to cooktop bottom.
IMPORTANT: All connections must be
Use only
Do not use TEFLON® tape. You will need to determine the fittings required depending on your installation.
7