Transport
Use This
Position
Position 
First Time
Clevis
Pin
Hairpin
Clip
Figure 9
4.To transport tiller, lower the depth stake (use top adjustment hole).
5.To adjust the depth stake, remove the clevis pin and hairpin clip. See Figure 9. Move the depth stake to the desired setting.
6.To adjust the side shields, remove the wing nuts. See Figure 10. Place side shield in position desired. Replace wing nuts and tighten securely.
Use This | Side |
Hole for | Shields |
Lowest (Shallowest) |
|
Position |
|
Use This Hole for
Highest (Deepest)
Position
Figure 10
TO OPERATE THE TILLER:
1.Select the depth stake setting.
2.Start engine as instructed on page 9.
3.Move gear selection handle to one of the forward modes or reverse.
Use the reverse tine drive when tilling virgin ground, sod or hard soil. Use the forward tine drive when cultivating or tilling soft ground.
IMPORTANT: When using the forward tine drive, lower the depth stake (use a shallower tilling depth) to make certain the tines do not run across the ground.
WARNING: Do not move the gear selection handle with the wheels or tines engaged. Make certain the unit is stopped completely before changing the gear selection.
4.Squeeze the clutch control bail against the handle to engage the wheels and tines.
NOTE: Make certain the gear selection indicator is correctly positioned before engaging the clutch handle. If it is between gears, the engine will stall.
To transport tiller, do not engage the tines. Select the wheel drive only.
WARNING: Do not push down on the handles so that the wheels are lifted off the ground while using the reverse tine drive, or the tiller could move backward and cause personal injury.
For best results, it is recommended the garden be tilled twice (lengthwise, then widthwise) to pulverize the soil.
SECTION 9: ADJUSTMENTS
HANDLE ADJUSTMENT
The handle height may be adjusted. Refer to the Control section for details of handle adjustment.
BELT TENSION ADJUSTMENT
Periodic adjustment of the belt tension may be required due to normal stretch and wear on the belt. Adjustment is needed if the tines or wheels seem to hesitate while turning, but the engine maintains the same speed.
10
