White W338 Adjusting thread tension, Stitch length adjustment, Reverse sewing, Sewing Sleeves

OperatingtheSewE-Z

Adjusting thread tension

Tension for maximum performance has been set and adjusted at the factory. However, if you should find that stitches are too loose, or too tight, you can adjust the stitch.

1.Loosen stitch by turning the tension screw

(Q)counter-clockwise.

2.Tighten the stitch by turning tension screw

(Q)clockwise. Sewing heavier fabric may require loosening the stitch. Very light fabric may require tightening the stitch.

3.Bobbin tension cannot be adjusted.

Stitch length adjustment

You can use the stitch length adjustment button control to change the stitch length in sewing.

1.Push the button to the left in order to get the longest stitch length. This is recommended for normal sewing.

2.By turning the button towards the right hand side, the stitch length will be reduced.

3.When the button is set to the middle point, the stich length will become zero, therefore, the fabric will not move forward.

Reverse sewing

Push and hold the lever down to sew in reverse.

Sewing Sleeves

The machine designed to allow you to sew sleeves easier.

1.Lift up the presser foot (F) and position the sleeve under the needle. Put the bobbin part of the sleeve in the gap between the platform and the base.

2.Lower the presser foot and follow the step 5-13 in the section of operating the machine on the previous page. Now you can sew the sleeve easily.

9