White W338 instruction manual Threading the machine, Threading main unit using side, Bobbin

Threadingthemachine

Threading the machine

1.Raise thread spindle (C) by grasping the exposed top and pulling upward until thread spindle (C) is fully extended.

2.Place thread spool (E) on the

	thread spindle (C) as shown.	2
3.	Pull thread from the thread
	spool (E) on the thread spin-	1
	dle (C) and put it through the
	thread holder (1) in the direc-
	tion toward front of machine.	3
4.	Bring thread across to the
	thread tension screw (2).	4
	Thread goes over the tension
	adjusting screw and must be
	positioned between the two
	washers behind the tension	5
	adjusting screw(Q). This is
	what provides the lockstitch
	tension to the thread.
5. Pull thread from tension		6
	adjusting screw (Q) guide

through thread take up lever

(D) in the direction toward front of machine (3).

6. Pull thread through thread guide (4) inserting in the direction toward the front of the machine.

7. Pull thread down to thread

guide (5) and insert thread
from the top downward. If
necessary, lower the needle
(R) to reach this guide by
turning the hand wheel (K)	Threading main unit using side
slightly counter-clockwise (in the direction
	bobbin
toward you) to lower the needle (R).
8. Raise the needle (R) to reach the eye by	(Follow steps 4-10 with these exceptions.)
turning the hand wheel (K) slightly	1. Pull bobbin spindle (U) out from main unit.
clockwise (in the direction away from you).
	2. Insert bobbin spindle (U) through center
Insert thread through eye (6) of the needle
	hole of threaded bobbin.
from the front toward the back of the
	3. Insert bobbin spindle (U) (with bobbin
machine (use threader accessory if
	attached) into bobbin holder (V). Make
necessary).
	sure bobbin spindle (U) with bobbin are
9. Raise the Presser Foot (F) by lifting up on
	tightly secured to main unit.
the lever at the rear of machine (G).
	Note: thread main unit with side bobbin
10.Pull about 10 inches of thread through the
	simultaneously with thread spool for a double
needle (R) and lay it on the deck under the
	stitch method. Side bobbin is to be used only
presser foot (F) running in the direction
	if you’re using this particular method of
away from you.
	stitching.

5