SIPHON PLUG
Pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly.
THE CABINET
Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. After rinsing with clean water, wipe it with a soft and dry cloth.
WARNING!
If the machine is installed in a location where the ambient temperature can fall below 0 ˚C, do the following when it will not be in use:
•Plug in the machine.
•Close the water tap and pull out the water inlet hose or hoses from the tap.
•Place the ends of the water drain and water inlet hoses in a cup on the ground.
•Adjust the program knob to “Draining” program.
•The program ready light will be on.
•Run the program by pressing the start/pause button.
•Unplug your machine when the program is over (program end light is on).
When you complete these proces, the remaining water inside the machine will be drained and thus formation of ice in the machine will be prevented. When you operate your machine again, be sure that the ambient temperature is above 0 ˚C.
THE DRUM
Do not leave metal parts like needles, staples or coins inside your machine. These pieces cause formation of rust stains in the drum. To eliminate these stains of rust, use a cleaning substance without chlorium and follow the warnings of the cleaning substance producer. For cleaning of the rust stains, never use
REMOVE OF LIME FROM YOUR MACHINE
If you arrange the amount of the detergent you use in your machine properly, there will be no need for lime removal. However, if you desire to apply the removal procedure, use the lime protectors in the market and pay attention to their warnings.
WARNING!
The lime eliminating substances contain acids and this may cause colour modifications in your clothes along with an adverse effect on your machine.
45
