White Outdoor 400 warranty Setup Adjustments a

3

Setup and

Adjustments A

	B
WARNING	Figure 3-1

NOTE: The units illustrated may vary slightly from your unit.

1.	Remove any packing material which may be between
	upper and lower handles.
	a. Pull up and back on the upper handle to raise the
	handle from position A into the operating position.
	See Figure 3-1.
	b. Tighten hand knobs securing upper handle to
	lower handle. Make sure that each carriage bolt is
	seated properly in the handle.
2.	Place one carriage bolt (found in the hardware pack
	included with your unit) in the upper hole of the right
	handle mounting bracket from the inside outward. See
	Figure 3-2. Secure with one wing nut. Repeat process
	on the left side.
3.	Rope guide Setup as follows, see Figure 3-3:

Disconnect and ground the spark plug wire as instruct- ed in the separate engine manual.

IMPORTANT This unit is shipped

WITHOUT GASOLINE or OIL. After assem- bly, service engine with gasoline and oil as instructed in the separate engine manual packed with your unit.

Figure 3-2

A

B

D

C

a.	Hold the blade control against the upper handle.
	Position A.
b. Slowly pull starter rope out of engine. Position B.
c.	Slip starter rope into the rope guide. Position C.
	Loosen rope guide wing nut if necessary.
d.	Tighten rope guide knob. Position D.
4. Insert post on cable tie into hole provided on the lower
handle. Pull cable tie tight and trim excess. See Figure
3-4.
5. Each wheel has a height adjustment lever to change
the cutting height of the mower. To change the height
of cut, squeeze adjuster lever toward the wheel,
moving up or down to selected height. See Figure 3-5.

Figure 3-3

Figure 3-4