• |
Screw |
• |
• |
Belt Cover |
To remove the front auger drive belt, push the idler pulley to the left. The belt brake should move outward and lift the front auger drive belt from the front auger pulley.
Place new belts on the two auger pulleys making sure that the front auger belt is under the belt brake. Route belts under and to the left of the flat idler pulley. Hold the belts upward in this position. While lifting up on the handles, bring the frame assembly close to the auger housing and place the two belts on the front and rear engine pulleys. See Figure 16.
Figure 13
•Remove the three hex nuts and lock washers which attach the auger housing assembly to the frame assembly on each side. See Figure 14.
Push
Frame
Assembly
• |
Hex Nuts & |
Lock Washers |
Push 
Auger
Assembly
Figure 16
Level the frame assembly and tip the auger housing forward to align studs with the corresponding holes on both sides of the frame assembly.
Figure 14
•Standing in the operating position, lift up on the handles and pull the frame assembly rearward. The frame and the housing will separate and the rear auger belt will come off the pulley. Maintain control of the frame assembly while pulling it.
•Remove the two belts from the two engine pulleys. See Figure 15.
NOTE: Use care to avoid pinching the control cable.
•From the frame assembly side, insert the six lock washers and hex nuts previously removed onto the studs. Tighten nuts securely. See Figure 14.
•Reinstall the belt cover on the front of the engine with the two
NOTE: Make sure that the auger cable is routed in front of the belt.
|
| Drive Belt |
| Remove Belt | • Drain the gasoline from the snow thrower or place a |
| piece of plastic under the gas cap. | |
|
| |
Remove Belt |
| • Remove the plastic belt cover on the front of the |
Idler Pulley |
| engine by removing the two |
| • Tip the snow thrower up and forward, so that it rests | |
|
| |
|
| on the housing. |
|
| • Remove six |
|
| cover underneath the snow thrower. |
|
| • Pull the idler pulley away from the drive belt and |
|
| remove the belt from the engine pulley. |
|
| • Working from the underside of the frame, slip belt |
|
| between the friction wheel and the friction wheel |
|
| disc. You may have to twist the belt flat in order to |
Figure 15 |
| slide it through the clearance between the friction |
| wheel and the friction wheel disc. Remove and | |
|
| 13 |
