Flange Nut Retainer Bracket |
Shoulder Bolt |
Lock Nut |
Lift up |
Handle |
Figure 3
•Place the hex opening of the hex nut retainer bracket over the flange nut securing the handle adjustment lock and install the lock nut on the lower shoulder bolt. See Figure 4.
•Pivot handle assembly into the highest position possible. Tighten the bottom bolt and nut securely. Tighten the handle adjustment lock.
•Insert the end of the gear shift rod through the opening in the top of the shift cover, and into the shift bracket. Secure with rubber washer first, then flat washer and hairpin clip. See Figure 6.
•Install the nut and
| Gear Shift Rod |
Shift Cover | Opening |
| |
| Rubber Washer |
| Flat Washer |
| Hairpin Clip |
Figure 6
|
| Attaching The Clutch Cable | |
Hex Hole in | Handle Adjustment | • Route the clutch cable underneath the handle and | |
Retainer Bracket | Lock | through the cable clip. Be careful not to bend or | |
over Flange Nut |
| kink the cable. See Figure 7. | |
|
| Handle | |
|
| Adjustment | |
|
| Lock | |
|
| Cable | |
|
| Clip | |
Figure 4 |
|
| |
Attaching The Gear Shift Rod |
| ||
• Remove the |
| ||
and rubber washer from the end of the gear shift | Flange Lock Nut | ||
rod. Slide the rod up through the bracket on the | |||
| |||
front of the handle assembly. See Figure 5. | Figure 7 | ||
| • Remove one hex nut from the threaded casing on | ||
|
| ||
|
| the end of the cable and slip the wire up through the | |
|
| slot on the cable bracket underneath the handle. | |
|
| See Figure 8. | |
Gear Shift |
| • Push the end of the casing up through the cable | |
| bracket. Rethread the hex nut on the end of the | ||
Rod |
| ||
| cable. Do not tighten at this time. | ||
|
| ||
|
| • Pull the cable upwards to obtain slack and from | |
|
| right to left hook the “Z” end of the cable into the | |
|
| bracket on the clutch control (beneath the handle | |
|
| panel). Tighten the nut against the cable bracket. | |
Figure 5 |
| See Figure 8. | |
|
|
6