Belt Replacement | • Remove belt and reassemble new belt, following | |
• Disconnect and ground the spark plug wire against | instructions in reverse order. | |
NOTE: Upon reassembly, make certain the belt is | ||
the engine. | ||
• Remove two torx head screws from the top of belt | routed over the idler pulley and inside of belt keepers by | |
cover. | engine pulley. |
•Remove two hex cap nuts and flat washers from
front side of the belt cover. Remove the hex nut and |
| ||
flat washer at the back of the cover. | • Clean the exterior of engine and the entire tiller | ||
• Remove the belt keeper assembly located behind | |||
thoroughly. Lubricate the tiller as described in the | |||
the engine pulley by removing two hex bolts and | |||
Lubrication Section. | |||
lock washers. See Figure 12. | |||
• Refer to the engine manual for correct engine | |||
|
| ||
Engine |
| storage instructions. | |
Belt Keeper | • Wipe tines with oiled rag to prevent rust. | ||
Pulley | |||
• Store tiller in a clean, dry area. Do not store next to | |||
| |||
|
| ||
|
| corrosive materials, such as fertilizer. | |
| Hex Bolts |
| |
Belt | Idler |
| |
Pulley |
| ||
Keeper |
| ||
|
| ||
| Figure 12 |
| |
11
