Installation Instructions for
Cooling only1C21
YOUR THERMOSTAT REPLACES
Description | 1C21 |
|
|
Standard Heating & Cooling Systems - 4 or 5 wires | No |
Standard Cool Only Systems | Yes |
|
|
Millivolt Cool Only Systems - Floor or Wall Furnaces | Yes |
Standard Central Air Conditioning | Yes |
|
|
Gas or Oil Heat | No |
Electric Furnace | No |
Hydronic (Hot Water) Zone Heat - 2 Wires | No |
|
|
Hydronic (Hot Water) Zone Heat - 3 Wires | No |
|
|
Heat Pump (No Aux or Emergency Heat) | No |
Heat Pump (with Aux or Emergency Heat) | No |
Baseboard Electric Heating or Line Voltage (120 or 240 Volt) | No |
|
|
|
|
CONTENTS |
|
Preparations | 1 |
Thermostat Features | 2 |
Removing Old Thermostat | 3 |
Mounting and Wiring | 4 |
New Thermostat Operation | 5 |
Specifications | 6 |
Troubleshooting | 7 |
1 PREPARATIONS
Assemble tools required as shown below.
FLAT BLADE SCREWDRIVER | WIRE CUTTER/STRIPPER |
HAND OR POWER
DRILL WITH 3/16 INCH
DRILL BIT, IF NEEDED
SPIRIT LEVEL OR PLUMB BOB AND LINE OPTIONAL—
THERMOSTAT MUST BE LEVEL TO WORK PROPERLY
Failure to follow and read all instructions carefully be- fore installing or operating this control could cause personal injury and/or property damage
2 THERMOSTAT FEATURES
MOUNTING SCREWS
CAPTIVE SCREWS
BASE
COVER
| Adaptor Plate |
Figure 1. | (optional) |
3 REMOVING OLD THERMOSTAT
!CAUTION
To prevent electrical shock and/or equipment damage, disconnect electrical power to the system at the main fuse or circuit breaker until installation is complete.
Before removing wires from old thermostat’s switching subbase, label each wire with the terminal designation it was removed from.
Some models also include an adaptor plate to cover unpainted surfaces. Thermostat wires pass through the adaptor plate center opening.
1.Remove Old Thermostat: A standard heat/cool thermostat consists of two basic parts:
a.The cover, which may be either a
b.The base, which is removed by loosening all captive screws.
ATTENTION! This product does not contain mercury. How- ever, this product may replace a unit which contains mercury.
Do not open mercury cells. If a cell becomes damaged, do not touch any spilled mercury. Wearing
Mercury must not be discarded in household trash. When the unit this product is replacing is to be discarded, place in a suitable container. Refer to
| PART NO. |
Replaces | |
0835 |