|
|
|
| ||
|
| Heating Only Systems) |
|
| INSTALLATION INSTRUCTIONS |
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
This
PRECAUTIONS
If in doubt about whether your wiring is millivolt, line, or low Do not exceed the specification ratings. voltage, have it inspected by a qualified heating and air
conditioning contractor, electrician, or someone familiar with basic electricity and wiring.
CONTENTS |
|
Description | 1 |
Precautions | 1 |
Specifications | 2 |
Installation | 2 |
New Installation |
|
Select Thermostat Location |
|
Route Wires to Location |
|
Replacement Installation |
|
Remove Old Thermostat |
|
Attach Subbase to Wall |
|
Attach Thermostat to Subbase |
|
Operation | 5 |
System Configuration |
|
Energy Management Recovery (EMR) |
|
Check Thermostat Operation |
|
Heating System |
|
Troubleshooting |
|
All wiring must conform to local and national electrical codes and ordinances.
This control is a precision instrument, and should be handled carefully. Rough handling or distorting compo- nents could cause the control to malfunction.
!CAUTION
To prevent electrical shock and/or equipment damage, disconnect electric power to system, at main fuse or circuit breaker box, until installation is complete.
!WARNING
Do not use on circuits exceeding specified volt- age. Higher voltage will damage control and could cause shock or fire hazard.
Do not short out terminals on gas valve or pri- mary control to test. Short or incorrect wiring will burn out thermostat and could cause personal injury and/or property damage.
PART NO. | ||
EMERSON ELECTRIC CO. | ||
9797 REAVIS ROAD | Printed in U.S.A. | |
9151 | ||
RST. LOUIS, MISSOURI |