White Rodgers 24A06G-1 specifications Installation, Wiring And Operation, Connection Table

INSTALLATION

The Dual-Level Temp relay may be mounted in any position without affecting it's performance.

It can be connected using the 1/2" male conduit hub and

can be mounted to any standard junction box or wiring compartment.

It can also be mounted using the two holes in the back of the case. Location of the mounting holes may be simplified by holding the control against the mounting surface and marking the proper position for drilling the holes.

4 15/16"

1 3/32"

3 25/32"

2 1/8"

9/32"	3 15/32"	9/16"
3/8"
		9/32"
7/32"
		3 1/16"

9/16"

1/2" STD CONDUIT HUB

1 3/32"

Fig. 1. Dimensions of Type 24A06 Dual Level Temp

WIRING AND OPERATION

All wiring should be done in accordance with local and national electrical codes and ordinances.

If a wiring diagram is supplied with the heating equipment, follow those instructions. If none is available, two diagrams are presented which show different wiring methods for the Silent Operator relay.

NOTE

Use thermostat with a .4A fixed heater, or set adjustable heater in thermostat at .4A.

TYPE 24A06 DUAL LEVEL TEMP

WR

2-WIRE

HEATING THERMOSTAT

Connection Table

2-Wire Thermostat (R & W)	Black w/White stripe and
	White to terminal W. Red to
	terminal R.
Power Input:	Black & Blue
Heat Load 1:	Red & L2
Heat Load 2:	Black w/Red stripe & L2

OPERATION

As the thermostat closes its contacts, bimetal heaters #1 and #2 are energized. Approximately 45 seconds later, the warp- ing action of these heaters closes line voltage switches #1 and #2 to energize heating loads #1 and #2.

When the thermostat opens its contacts, bimetal heaters #1 and #2 cool for approximately 45 seconds before line voltage switches #1 and #2 open to de-energize the heating loads.

HEATING

LOAD #1

	BLACK
WHITE	W/WHITE
	STRIPE
RED
BIMETAL	BIMETAL
HEATER #1	HEATER #2

SWITCH #1

TRANSFORMER

SWITCH #2

BLACK W/RED STRIPE

R		RED W/BLACK STRIPE
E
D	B
	L
	A
	C			HEATING
				LOAD #2
	K
	B
	L
	U		L1	L2
	E
		WIRING		LINE

Line Voltage

Line Voltage Field

Low Voltage

Low Voltage Field

L1L2

LINE

	Fig. 2. Using Two-wire Heating Thermostat to
2	Operate Two Separate Heating Loads