Whynter BWR-18SD, BWR-33SD Troubleshooting Guide, Problem, Possible Cause, Solutions

Models: BWR-33SD BWR-18SD

1 15
Download 15 pages 28.11 Kb
Page 14
Image 14

TROUBLESHOOTING GUIDE

Most common problems can be resolved by referring to the troubleshooting suggestions listed below.

PROBLEM

POSSIBLE CAUSE

SOLUTIONS

The appliance does

There is a power failure.

Ensure the appliance is plugged in and

not operate.

The appliance is not plugged in.

the power outlet has power.

 

A house fuse has blown or the circuit breaker is

Replace the broken fuse or reset the

 

tripped.

breaker.

 

 

The appliance is not

The set temperature too high.

Adjust the set temperature

cold enough.

The appliance is placed too close to a heat

Keep the appliance away from sunshine

 

source.

or other heat sources.

 

The door is opened too often.

Close the door tightly and do not open

 

The door is not closed completely.

the door too frequently or for a long

 

 

period of time.

 

The door gasket does not seal properly.

Ensure the door gasket is not loose.

 

The front bottom grille does not have sufficient

The front bottom grille must be

 

ventilation.

completely unobstructed.

The appliance turns

The ambient (room) temperature is too low or

Decrease or increase the ambient

on and off frequently.

high.

(room) temperature.

 

 

To minimize internal temperature

 

A large amount of contents has been added to

fluctuation, do not add large amount of

 

the appliance.

contents at once.

 

 

Close the door tightly and do not open

 

The door is opened too often.

the door too frequently or for a long

 

The door is not closed completely.

period of time.

 

The door gasket does not seal properly.

Ensure the door gasket is not loose.

 

 

The appliance makes

The noise may come from the flow of the

It is normal that as each cooling cycle

too much noise.

refrigerant/

ends, you may hear gurgling sounds

 

 

 

caused by the flow of refrigerant in the

 

 

appliance.

 

Contraction and expansion of the inside walls

Some popping or cracking noises are

 

may cause popping and crackling noises.

normal. They are caused by expansion

 

 

and contraction of the inside walls due

 

 

to temperature changes.

 

 

Make sure the cooler is on a hard and

 

The appliance is not level.

level surface. Do not place the

 

 

appliance on carpet.

The door does not

The appliance is not level.

Make sure the cooler is on a hard and

close properly.

The door was reversed and not properly

level surface. Avoid placing the

 

 

installed.

appliance on a carpeted or soft surface.

 

The shelves are out of position.

Correctly install the shelves.

14

Page 14
Image 14
Whynter BWR-18SD, BWR-33SD instruction manual Troubleshooting Guide, Problem, Possible Cause, Solutions