Operating Instructions
Before operating the furnace, read carefully all warnings and safety information in this manual.
FOR YOUR SAFETY READ BEFORE OPERATING 
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
|
|
|
| |
A. This appliance has a pilot which must be | Follow the gas supplier’s instructions. | |||
lighted by means of the piezo igniter | - If you cannot reach your gas supplier, call the fire | |||
installed on the unit. Do not try to light the | department. | |||
pilot by hand. | C. Use only your hand to push in or turn the gas control | |||
B. BEFORE LIGHTING smell all around the | ||||
knob. Never use tools. If the knob will not push in or turn | ||||
appliance area for gas. Be sure to smell | by hand, don’t try to repair it, call a qualified service | |||
next to the floor because some gas is | technician. Force or attempted repair may result in a fire or | |||
heavier than air and will settle on the floor. | explosion. | |||
WHAT TO DO IF YOU SMELL | D. Do not use this appliance if any part has been under water. | |||
GAS: | Immediately call a qualified service technician to inspect | |||
- Do not try to light any appliance | the appliance and to replace any part of the control system | |||
and any gas control which has been under water. | ||||
- Do not touch any electric switch; Do | ||||
|
| |||
not use any phone in your building |
|
| ||
- Immediately call your gas supplier |
|
| ||
from a neighbour’s phone. |
|
| ||
OPERATING INSTRUCTIONS 
1.STOP! Read the safety information above on this label.
2.Turn gas control knob clockwise
to OFF. Do not force.
3.Wait (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “B” in the safety information above on this label. If you don’t smell gas, go to the next step.
4.Turn gas knob counterclockwise 
to PILOT.
5.Look inside the flame view which is located on the external casing.
6.Push in control knob all the way and hold in. Immediately press the piezo igniter to end of the stroke, then release it. Continue pressing and releasing the piezo igniter with the control knob pressed down, until the pilot flame appears in the flame view. Once the pilot flame is lit, hold the control knob in for about one (1) minute.
7.Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 2. trough 6. .
-If knob does not pop up when released, stop and turn the gas tap installed on the gas supply line to the CLOSED position. Immediately call your service agency or gas supplier.
-If the pilot will not stay lit after several tries, turn the gas control knob to OFF and call your service technician or gas supplier.
8.Turn the control knob counterclockwise 
to the desired setting between HI and LO. The main burner flame will appear.
TO TURN OFF GAS TO APPLIANCE
1.Turn the control knob clockwise 
to OFF position. Do not try to switch from HI to OFF directly. Do not force.
2.Turn the gas tap installed on the gas supply to the CLOSED position.
9
