Instructions for the R7-4 Multi-Channel Receivers:
The
Re-Tuning the TOUR GUIDE System:
Radio Interference:
The TOUR GUIDE System is usually not disturbed by other radio services, however there is no such thing as a clear or exclusive channel for ANY radio service. One of the unique features of the Williams Sound TOUR GUIDE System is that the operating frequency can easily be changed in the field to avoid interference. There are ten possible frequencies for tour guide use
T16 Transmitter Frequency Change Procedure:
(Step 1) Remove the Transmitter from the Belt Clip Case. (Step 2) Open the battery door and remove the battery.
(Step 3) Grasp the right corner of the battery door and lift the flap up and to your left. The back of the Transmitter case will open like a book, exposing the circuit board.
(Step 4) Use the photo below to locate the channel selector switches.
(Step 5) Use the tip of a paper clip or a small screwdriver (not a pencil point) to move the switches to correspond with the switch positions on the programming chart. Select a new frequency at least two channels away from the one you are experiencing interfer- ence on. DO NOT TOUCH ANY OF THE OTHER ADJUSTMENTS!
(Step 6) Close the back of the Transmitter and install the battery. Plug the microphone in and turn the Transmitter on to provide a tuning signal for the receivers. See the next section
for receiver tuning instructions.
Page 9