Pivot
To pivot the Stock Feeder (for maintenance, oil filling, etc.):
1.Loosen the handle (E, Figure 10) and pull up on the pin (F, Figure 10).
2.Pivot the Stock Feeder into position. (NOTE: At 90 degrees of pivot, as shown in Figure 10, the pin will lock into place.)
3.
Operating Controls
Switch
The control switch is shown in Figure 11. The switch can be set to either Forward or Reverse (the arrows on the switch label reflect the direction of roller rotation).
Never put the stock feeder into reverse while the table saw blade is still rotating. Failure to comply may cause stock kickback and personal injury.
Speed Selection
The speed, or feed rate of the Stock Feeder is variable, ranging from 6.5 to 66 feet per minute. The speed is adjusted by setting the control switch (Figure 11) and rotating the transmission knob, shown in Figure 12. Rotating the transmission knob clockwise decreases the speed, counterclockwise increases it.
The speed is established when the edge of the transmission knob lines up with the appropriate line on the speed scale. See Figure 12. The speed scale is graduated in feet per minute, and meters per minute.
The transmission knob should only be adjusted when the Stock Feeder is operating; that is, when the control switch is in either forward or reverse.
Operation
IMPORTANT: Before operating the Stock Feeder, you should be thoroughly familiar with the safety and operating instructions that accompanied your table saw.
Keep hands away from rollers and blade area during operation. Failure to comply may cause injury.
Figure 10
Figure 11
Figure 12
13
