WINDCHASER PRODUCTS • ENGLISH
Thank you for choosing WINDCHASER PRODUCTS. We hope this product will give you complete satisfaction. If however a problem occurs, please contact your dealer or our customer service department.
READ AND KEEP INSTRUCTIONS |
|
CONTENTS |
|
VERY IMPORTANT | 1 |
TO SAVE ENERGY | 1 |
TECHNICAL SPECIFICATIONS | 1 |
LEARN INTELLIGENT | 2 |
SAFETY INSTRUCTIONS | 2 |
PARTS ILLUSTRATION | 3 |
INSTALLATION | 5 |
OPERATING | 6 |
VENTILATION ONLY | 6 |
AIR CONDITIONING | 6 |
TIMER PROGRAMMING | 7 |
DEHUMIDIFICATION OPERATION | 7 |
FAHRENHEIT & CELSIUS DISPLAY BUTTON | 8 |
DRAINING EXCESS CONDENSATE WATER | 8 |
CLEANING THE APPLIANCE | 9 |
LONG TERM STORAGE | 9 |
TROUBLESHOOTING GUIDE | 10 |
PRODUCT LIMITED WARRANTY | 11 |
SAFETY POWER SUPPLY CORD |
|
This unit is provided with a Leakage Current Detection and Interruption circuit (LCDI) built into the plug of the power supply cord. This device provides protection to reduce the risk of fire due to arcing faults in the
PLUG TESTING INSTRUCTIONS:
1.PRESS TEST BUTTON. UNIT SHOULD TRIP.
2.PRESS RESET BUTTON FOR USE.
DO NOT USE IF ABOVE TEST FAILS.
The conductors inside this power supply cord are surrounded by shields which monitor the leakage current. These shields are not grounded. Periodi- cally examine the cord for any damage. If the shield gets exposed, immediately unplug the power supply cord and do not use the unit.
Do not repair a damaged cord. Replace the damaged cord only with a new replacement power supply cord obtained from the manufacturer.
In the event the LCDI Plug of the power supply cord trips by itself, then first examine the cord for any damage. If there is no damage to the cord then press the RESET Button. If the LCDI Plug trips again, then immediately unplug the power supply cord. Replace the damaged cord with a new replacement power supply cord.
To obtain a new replacement power supply cord contact WindChaser Products Customer Service at:
(800)
Do not use The TEST and RESET Buttons as an on / off switch. They are only meant to be used to periodically check the LCDI plug.