MACHINE OPERATION
PRE-RUN INSPECTION
1.Check all fittings and connectors for proper assembly.
2.Check all hoses for leaks. Repair or replace any damaged hoses.
3.Check power cord(s) for any damage. If damaged, replace.
EQUIPMENT SET-UP
1.Plug power cord from machine into properly grounded wall outlet.
2.Turn vacuum motor switch on and off to make sure there is electrical power at machine.
3.Connect vac hose to machine. Slide the swivel cuff over the outlet on the tank.
4.Connect the hose to your machine and wand. Pull back the knurled collar on the quick disconnect coupler and push onto the connection on the chassis. To avoid leaks, check to be that a positive connection was made.
5.Using a clean container, fill the solution tank with clean hot water. Mix in a
extraction machines, following the manufacture’s instructions printed on container.
NOTE: When using a powder cleaner,
6.Turn pump and vacuum switch(s) to the on position.
7.Start cleaning.
PRIMING THE PUMP (SELF PRIMING VALVE) [High Pressure Pump Models ONLY]
Turn pump and both vacuums on.
1.Press lever (located above the accessory connection; front of machine) toward machine.
2.Do this for 30 seconds or until there is a steady flow of water flowing through the sight tube. (located on right side of recovery tank.)
EMPTYING AND CLEANING
Always use defoamer if foaming occurs. Foam will
suspend large particles that may damage vacuum(s) as well as allow liquid into the vacuum motor(s) without activating the float shutoff.
1.Before proceeding, make certain that the nozzle is functioning properly.
a.To check, hold the wand about one foot above the surface to be cleaned and open the wand valve. A full spray should be observed from the nozzle.
b.If the nozzle is not showing a full spray pattern, adjust nozzle for proper pattern, clean, or replace nozzle.
2.Normally, chemical is applied on the push stroke of the wand when cleaning. Vacuuming is done on the pull stroke. For heavily soiled carpets the wand may be used in a scrubbing manner, applying chemical in both the push and pull stroke.
3.When cleaning, keep the working opening (wand mouth) flat on the surface being cleaned. Keep the wand moving when the valve is open.
4.The shutoff float inside the vacuum tank will impede the vacuum flow when the vacuum tank is full.
When this occurs, empty the vacuum tank by opening the dump valve and dispose of the waste in a proper manner.
5.Once the vacuum tank has been emptied, you may once again proceed with cleaning
NINJA INTL 86038610 03/29/07 |
