OPERATIONS
EQUIPMENT | NOTES:____________________________ | |
1.) | Plug power cable from machine into | ___________________________________ |
properly grounded wall outlet. | ___________________________________ | |
|
| ___________________________________ |
2.) | Turn vacuum motor switch on and off | ___________________________________ |
to make sure there is electrical power at | ___________________________________ | |
machine. | ___________________________________ | |
|
| ___________________________________ |
3.) | Connect vac hose to machine. Slide | ___________________________________ |
the swivel cuff over the outlet on the tank. | ___________________________________ | |
|
| ___________________________________ |
4.) | Connect the hose set to the machine | ___________________________________ |
and wand. Pull back the knurled collar on | ___________________________________ | |
the quick disconnect coupler and push onto | ___________________________________ | |
the connection on the chassis. To avoid | ___________________________________ | |
leaks, check to be sure a positive | ___________________________________ | |
connection was made. | ___________________________________ | |
|
| ___________________________________ |
5.) | Using a clean container, fill the | ___________________________________ |
solution tank with clean, hot water. Mix in a | ___________________________________ | |
___________________________________ | ||
hot water extraction machines following the | ___________________________________ | |
manufacturer's instructions, as printed on |
| |
the container. When using a powder |
| |
cleaner, premix with hot water in a clean |
| |
container before adding to the solution |
| |
tank. | Serial | |
|
| |
6.) | Turn pump and vacuum switch to the on | Number:____________________________ |
| position. | _____________ |
7.) | Start cleaning. | Date |
|
| |
|
| Purchased__________________________ |
|
| ______________ |
5 | |
|