PRE-RUN MACHINE INSPECTION
Perform a
STARTING MACHINE
NOTE: Perform
FOR SAFETY: Before starting machine, make sure that all covers are in place and secured properly.
1.Connect the machine to a power supply.
2.Take the machine out of the tray. Do this by leaning the machine back and wheeling away from the tray. NOTE: Place the tray out of the way when machine in use.
3.Release the handle lock.
4.Depress the foot switch to engage machine.
After applying a light spray of diluted Red Carpet Rombus Carpet Clean onto the carpet using a pressurized tank sprayer, commence cleaning by pushing and pulling the machine slowly over the wetted carpet.
Best results are obtained by moving the machine in multiple directions and overlapping strokes.
! 
Flammable materials can cause an explosion or fire. Do not use flammable materials with this machine.
MACHINE OPERATION
MACHINE SHUT-DOWN AND
STORAGE
1.Depress the foot switch to power off machine.
2.Lock handle in the upright position.
3.Disconnect the power cord from the power supply. Wind the power cord around the cable holder on the handle.
4.Remove the brushes for cleaning. See Brush Cleaning and Maintenance section.
5.Once daily maintenance has been performed, place the machine back into the tray.
The machine is now ready for storage until the next use. Make sure to store your equipment in a dry place to prolong the life of your machine. Storage outdoors or unprotected could cause damage to your machine or internal parts, therefore voiding your warranty.
! |
When not in use or during interrupted cleaning, the machine must always be placed in the tray provided to prevent deformation of the brush bristles. Deformation of brush bristles can result in unbalanced running and excessive vibrating or jumping.
ROMBUS 980124 07/02/03 | |
|
