Quick Setup for One Receiver
1Make sure the Pathway X2 antenna is in a location with a clear view of the southern sky.
2Align the Pathway X2 antenna so that cable connections are facing approximately North.
3Connect the primary receiver to the “MAIN” port on the base.
4After connecting the receiver to a power source, complete receiver setup. Select the number of receivers, eastern or western arc, and the state that you are currently in. Then, press “Scan” to start scanning for satellites.
5Watch TV!
Specifications
Compatible with DISH programming and DISH Solo HD receivers
Supports up to two receivers For stationary use only Includes 25 ft coaxial cable Unit weight: 16 lbs Stowed height: 15 in
Max. height deployed: 20.75 in
Diameter: 21 in
Reflector size: 18 in
Elevation range:
Made in USA
Reflector cover
Protects inner components from environment
Handle
Enables easy carrying of antenna
Eyelet
Enables securing of antenna to site
Secondary port
Connects to secondary receiver
Main port
Connects to primary receiver
Antenna Feet
The Pathway X2 antenna has four feet on the bottom of the unit. Each foot has two mounting spots on the underside of the antenna. The antenna will come with the feet in the inside holes. If mounting the antenna on Winegard Model
Compatible Satellites
The Pathway X2 antenna can receive programming from DISH eastern or western arcs.
Compatible Receivers
DISH Eastern Arc Satellites 61.5°, 72°, 77°
DISH eastern arc will work in most areas of the country but may not be available in the Northwest. If unavailable, use the western arc.
Warnings
!Do not use excessive force when manually rotating the antenna, as this could cause damage to motors and gears.
!The antenna is not intended for permanent mounting on any vehicle.
!Do not place the unit in water >2 in. deep, or water may damage the electronics.
1
DISH Western Arc Satellites 110°, 119°, 129°
DISH western arc will work in most areas of the country; if unavailable, use the eastern arc. Western arc may be required for initial setup and software download.
!Do not install or operate the antenna in winds of 35 mph or greater. The antenna will roll in winds ≥35 mph.
!Do not insert your fingers around the base while the antenna is moving.
!Care should be taken when transporting and setting up the antenna. Do not toss or drop the antenna.
!Do not paint the antenna. Painting the antenna may cause signal degradation and will void your warranty.
The Pathway X2 antenna must be used with DISH Solo HD receivers. Examples of DISH Solo HD receivers include DISH 211z, 211k, 211, and 411 receivers.
!The antenna is not meant for use with the Carryout® ladder mount. Installing the antenna on the Carryout ladder mount may lead to serious injury and/ or equipment and property damage.
!A 25 foot coaxial cable is included and recommended for use with the antenna. Longer coax runs could potentially cause intermittent problems. Maximum cable length should never exceed 50 feet.