Winegard warranty Winegard, Model HD-1080DTV Antenna, Register your product at, Attach

90 DAY LIMITED WARRANTY

WINEGARD®	Register your product at
Model HD-1080 DTV Antenna
	winegard.com/myantenna

WARNING

READ THE ACCOMPANYING SAFETY INSTRUCTION SHEET BEFORE PROCEEDING WITH ANTENNA AND/OR MAST ASSEMBLY AND INSTALLATION. INSTALLATION OF THIS ANTENNA NEAR POWER LINES IS DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.

FRONT

Front Boom	Phasing Lines
Reflector
Elements	(Hex Nuts)
Spacers	Downlead Connection
	Matching
Reflector	Transformer
	(must face TV station)

Reflector

Element

FIGURE 1	Bolt	Hex Nut	Attach
			antennas
			together with
Mast			bolts and hex
Clamp			nuts installed
			in larger
U-Bolt			section.
		Spacer
	Mast (2" OD Max.)
		*not included

Repeat both steps indicated on other end of boom.

	FIGURE 2
Bolt	Mast Clamp
Back	Nut
Boom

Step 1. Remove antenna from carton. Unfold elements and reflectors. Make sure that they are straight and perpendicular to the boom.

Step 2. Attach mast clamp to the back boom (larger antenna section) antenna using the screw and hex nut supplied, Fig. 2.

Step 3. Using the bolts and hex nuts provided, attach the smaller section to the larger section of the antenna using the spacers as shown in Figure 1.

Step 4. Mount antenna on top of mast and lightly tighten mast clamps.

Step 5. On the back of the smaller section, line up the two phasing lines and insert the smaller screws from the hardware bag so that the head of each screw faces the larger section of the antenna. Place two washers on each screw and install the nut to hold the washers in place DO NOTTIGHTEN. Connect matching transformer to the downlead connection. Slide spade lugs of matching transformer between the washers. Tighten hex nuts securely. With the screws in place, connect the coax downlead to the matching transformer on the antenna, but do not secure at this time. Then connect the coaxial cable to your TV.

Step 6. Point front of antenna towards stations and tighten mast clamp securely, Figure 1. Step 7. Secure coaxial downlead to the mast using tape to prevent whipping by the wind.

Step 8. Ground antenna and mast per accompanying Safety Instruction sheet.

*Grounding the antenna is not required for indoor installations.

WINEGARD®

Printed in U.S.A. © Winegard Company 2009 • Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601-2000 Rev7 12-13 1450510