Winegard RM-DM61/DM55 owner manual Cable-entry plate Minimum 3 from mount base

STEP 3. Remove backing from gasket. Attach adhesive side to base plate. IF YOU ARE USING THE ROOF WEDGE (RW-5000), use 3/16” gasket included with the mount UNDER the roof wedge. Install the 1/16” gasket included with RW-5000 BETWEEN the mount

and roof wedge.See Figure 7.

The word FRONT is

embossed on the base. This MUST FACE the front of the vehicle. Secure to roof using two mounting

screws provided. Check inside the vehicle.PINS Be sure the shaft is centered in the hole. Attach crank handle to shaft.

Crank unit up until it stops.

FIGURE 6

RS-1000 ANTENNA

(4)ANTENNA MOUNTING BOLTS

E-CLIPS

REFLECTOR

Attach RS-1000 to

ELEVATING TUBES using

E-Clips and Pins supplied.

(4)1/4 - 20

HEX NUT

STEP 4. Attach reflector to backup assembly, Figure 6.

STEP 5. Attach RS-1000 antenna to elevating tubes. Use the two E-clips and pins provided, Figure 6. Attach coax cable to F-jack on antenna and slide on weather boot, Figure 6.

STEP 6. Install remaining mount base screws. Install the vent tube on the back of the mount base. (This is the side opposite the word FRONT.) The hole for the vent tube is shown in Figure 8.

CAUTION: DO NOT seal hole in vent tube. Put sealant around the outside of the vent tube, approximately 1/2” from end, Figure 8. Push the vent tube into the hole. The sealant will seal the hole as you push in. Leave approxi- mately 2 to 2-1/2” of the vent tube extending from the hole. Put a small amount of approved sealant on the roof and under the vent tube to hold in place.

FIGURE 8

FIGURE 7

Cable clamp

Do not attach cable clamp with screw to base plate until installing cable.

Cable-entry plate Minimum 3” from mount base

Base plate

6-1/8”

Travel Bracket

6