STEP 19. The directional handle and threaded rod will fit roofs up to
WITH ROOF WEDGE
Measure from top
of roof wedge to ceiling.
TOP OF
ROOF WEDGE
WITHOUT ROOF
WEDGE
Measure from top of roof to ceiling.
TOP OF
ROOF
³ FIGURE 13
CEILING ³
FIGURE 14
³
CEILING
³
Plastic Plug
STEP 20. Press the directional handle onto the hub. Point the arrow on the directional handle towards the rotate/lock lever to orient to the splines.
Spacer | STEP 21. Install the washer and nut on the | ||
Spring | |||
threaded rod. Tighten the nut enough to snug the | |||
| |||
| directional handle to the hub. | ||
| STEP 22. IF YOU ARE USING AN EXTEN- | ||
Hub | SION, adjust the total length of the directional | ||
| handle and extension by cutting the directional | ||
| handle. After adjusting parts for proper roof | ||
| thickness, glue the extension to the directional | ||
Worm | handle. Use ABS (plastic pipe) glue. | ||
Gear | NOTE: For roofs thicker that | ||
| |||
Threaded | aluminum hex shaft will be needed. Contact | ||
Rod | Winegard Company for this part. | ||
Ceiling | CUTTING SHAFT | FIGURE 14A | |
| |||
Plate | LENGTH, Figure 14A: |
| |
|
| ||
| Flip down handle on the |
| |
| elevating crank handle. |
| |
| Slide elevating crank | Elevating shaft | |
| handle up shaft until | Cut elevating | |
| snug against directional | ||
Directional | shaft at inside | ||
handle. Mark the | surface of | ||
Handle | |||
| elevating shaft at | crank handle | |
| inside bottom surface | housing; shaft | |
| goes through | ||
| of crank handle | ||
| |||
| housing, Figure 12. Cut | opening by | |
| shaft at mark, after | screw. | |
| removing crank handle. | Crank Handle | |
Reinstall crank.
STEP 23. Check system for proper operation. Elevate dish with crank handle. A minimum of 14 turns is needed to elevate dish. Then, move directional handle with dish elevated. Directional handle should turn freely. If possible, have someone watch to make sure coax does not bind or interfere with dish movement.
9
