WARNING: Use of this on/off power switch with any product other than Winegard amplified RV antenna, could result in fire or other damage.
APPLICATIONS AND
ALTERNATE CONNECTIONS
Antenna |
| Outdoor Receptacle |
|
| |
| Cable Input | |
|
| TV |
|
| Outlet |
Antenna | Set 2 | |
Input |
| |
|
| |
Cable Input |
|
|
Antenna | Outdoor Receptacle |
| |
Antenna | Cable |
Input | Input |
| Set 2 |
|
|
| |
ON/OFF |
|
|
|
Switch |
|
|
|
Set 1 |
|
|
|
| Example 2 |
| |
Antenna |
| Outdoor Receptacle | |
|
|
| |
| Cable |
|
|
Antenna | Input |
| TV |
Input |
| Set 2 | Outlet |
|
|
| |
INSTRUCTIONS
STEP 1. Select location for wall plate and patio receptacle if required. Run coax cables between locations and install connectors on each end. Mark cables so they may be identified. Antenna downlead and +12 VDC will also be needed at inside wall plate/power supply location.
STEP 2. The wall plate assembly may be flush mounted in most standard electrical boxes. To flush mount, cut a hole in wall to fit the box. Route all cables to the wall plate and other outlets required at this time. The Auxiliary jack is designed for the use of satellite receivers, etc. requiring direct line input.
WHEN CONNECTING CABLE OR WIRES BE SURE SWITCH IS IN OFF POSITION.
STEP 3. Make +12 VDC connection by running two #12 wires between the wall plate and +12 VDC source. Install terminals on wires from +12 VDC source as shown in Figure 1. Crimp terminals with Craftsman type 4 crimping tool or equivalent. Push wires onto tabs on terminal board as shown in Figure 2. If in doubt as to the polarity of the wires, connect them temporarily to tabs on circuit board and press
Connector Insulation
Figure 1
Figure 2
Crimp Here
Connector
Ferrule
1/4" #12 Wire
Remove 1/4" of insulation from #12 wire.
+12 VDC
Ground
ON/OFF | Set 1 |
Switch |
Example 1
Splitter 
ON/OFF
Switch
Set 1 Example 3
switch on front of outlet. If light comes on, polarity is correct. See Figure 3.
Auxilliary
Set 1 
Figure 3
