Winegard SDi installation manual Installation Wiring Specifications, Connecting the receiver

Installation • Wiring • Specifications

Connecting the receiver —

Connecting one receiver

1.Connect the coax cable from the gray coax cable of the RoadTrip™ to the “SATELLITE IN” on the receiver.

2.See page 5 of Operations Manual for receiver set-up.

Your RoadTrip™ has now been success- fully installed. Proceed to the Operation Manual for RoadTrip™ setup and for Op- eration Instructions.

Connecting two receivers

1.Connect the gray coax cable coming from the RoadTrip™ to the “SATELLITE IN” input on the primary receiver. The primary receiver is the receiver used most often and will toggle between satellites.

2.Connect the white coax cable coming from the RoadTrip™ to the “SATELLITE IN” input on the secondary receiver. NOTE: Secondary receiver will not toggle.

3.See page 5 of Operations Manual for receiver set-up.

Features and specifications

•One button operation.

•Dual receiver capable.

•Depending on receiver type, you can access satellites 119°, 110°, or 101°.

•No user input required.

•Elevation range 20° to 60°;

azimuth +360° (0-720°)

• Dome UV protected.

• Compact size —

32” diameter, 12-1/2” height

Shipping size - 37-1/4” x 34” x 14-3/4” Shipping weight - 55 lbs.

•Operating temperature -13°F to +140°F

•Specifications for max amperage 5.0A

•Specifications for unit operatating voltage. -10.5 - 13.8V

•Specifications for supply voltage. 12 - 13.8V

7