8
WOLF DUAL FUEL RANGE SURFACE OPERATION
BEFORE USING YOUR RANGE
Before using for the first time, you should
clean your dual fuel range thoroughly with hot
water and a mild detergent. Rinse and dry with
a soft cloth. This removes any residual oil and
grease left on the surface from the manufac-
turing process. Refer to care recommendations
on pages 25–26.
IMPORTANT NOTE:
Before using your dual
fuel range, check that the surface burner caps
are positioned correctly.
The optional griddle and French Top needs to
go through a ”burn in” period to clean oils
from the bottom of these assemblies. To
prevent food from sticking and to protect the
surface from moisture, it is necessary to
season the griddle and French Top prior to use.
Refer to the following pages for specific
instructions on using the optional charbroiler,
griddle and French Top.
FLAME HEIGHT AND APPEARANCE
Select a flame that is just high enough to
maintain the desired cooking speed and is
sized to fit the base diameter of the pan. Never
extend the flame beyond the base of the pan.
Smaller diameter pans should be used on the
left rear burner.
GRATE PLACEMENT
The low-profile, cast iron grates are designed
for a close fit. This enables you to move pans
easily from one burner to another without
having to lift the pan or have it tip over
between the grates. Each grate sets securely
on dimples on each corner of the burner pan.
Continuous grates are interchangeable, exclud-
ing the charbroiler grate with burner grate.
Position the porcelain-coated, cast iron grates
over two burners. Rubber pads located under
the grate support legs will match up with the
dimples on the burner pans.
The drip pan holds as much as 600 ml of liquid
spillover per two-burner pan.
CHARBROILER OPERATION
IMPORTANT NOTE:
The stainless steel cover
must be removed prior to operation of the
charbroiler.
Turn the knob counterclockwise to .
Preheat charbroiler for about 10 minutes
before adding the food. The ceramic tiles
will have an orange-red glow.
To turn the charbroiler off, turn the control
knob clockwise to the position.
INFRARED CHARBROILER
This optional feature is designed with an
infrared burner to give the highest quality and
most efficient method of gas grilling. A radiant
plate with numerous holes distributes the heat
evenly over the grate. The burner becomes an
orange-red color at the surface of the ceramic
tile, and when it glows, it transfers an intense
heat to the food. This sears the outside of the
food, leaving the inside tender and juicy.
The infrared burner is designed to operate at
5.6 kW (374 g/h) at 100% full heat output.
Before using the charbroiler for the first time,
place the radiant plate slots over the front
deflector of the charbroiler frame. The edges
of the charbroiler grate should line up on top
of the assembly.
To prevent flare-ups, you must never
leave the charbroiler unattended during
use.
Do not use cookware on the charbroiler
grate.