Wolf Appliance Company ICBIF15/S W O L F F Ry E R M O D U L E, Required Power Supply

Models: ICBIF15/S

1 43
Download 43 pages 22.9 Kb
Page 9
Image 9
Required Power Supply

W O L F F RY E R M O D U L E

E L E C T R I C A L R E Q U I R E M E N T S

Verify that power is disconnected from the junction box before proceeding.

Required Power Supply

220–240 V AC, 50–60 Hz, 15 amp service

Maximum Connected Load

2.6 kW

The Wolf electric fryer module requires a separate, grounded 3-wire 220–240 V AC,

50 –60 Hz, 15 amp service with its own circuit breaker or fuse. A properly rated cord should be attached to the power supply box of the fryer as shown in the illustration below. Open the power box to expose the screws with corresponding numbers. Loosen the 1, 5, and ground screws. Run the cord through the circular hole and into the power supply box. Attach the Neutral wire to the number 1 position. Line should be attached to the 5 position and attach the ground to the corre- sponding ground screw. After tightening the screws, close the cover to the power supply box without pinching any of the wires.

You must follow local codes and ordinances when installing your service.

IMPORTANT NOTE: The correct voltage, frequency and amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly sized circuit breaker or time delay fuse. The proper voltage, frequency, and amperage ratings are listed on the product rating plate located on the underside of the module. Refer to the illus- tration on page 5.

The wiring diagram covering the control circuit is located inside the module control box.

The complete appliance must be properly grounded at all times when electrical power is applied.

Improper connection can result in a fire hazard!

IMPORTANT NOTE: To avoid electrical shock when disconnecting the fryer module, all poles/wires must be disconnected from the power supply box.

Power supply box

10

Page 9
Image 9
Wolf Appliance Company ICBIF15/S W O L F F Ry E R M O D U L E, Required Power Supply, Maximum Connected Load