Wolf Appliance Company ICBIF15/S installation instructions D U L E I N S Ta L L At I O N

I N S TA L L AT I O N I N S T R U C T I O N S

M O D U L E I N S TA L L AT I O N B E F O R E O P E R A T I N G

To prevent pollution from entering the controller and transformer area, attach the foam strip to the underside of the module frame. Refer to the illustration below.

Gently lower the fryer module into the cut-out area in the countertop and center. Check that the front edge of module is parallel to the front edge of the countertop. Check that all required clearances are met.

To attach the brackets to the sides of the module, insert the clip into the rectangular punchout in the pan, and push down. Install the clamping screw into the bracket and tighten until the screw contacts the underside of the countertop. Do not overtighten screws. Refer to the illustration below.

IMPORTANT NOTE: Do not use caulk or silicone to seal the module to the countertop. The unit must be readily removable for service.

Read the entire Wolf Fryer Module Use & Care Information included with the module. Impor- tant safety and service information is contained within the book.

Thoroughly clean the stainless steel fryer basin, wire basket hanger and fryer baskets with mild soap and water before use.

Never operate the fryer module without oil; damage to the unit may result. Oil must be added to the fryer basin before turning on the module.

MODULE

FOAM

STRIP

Foam strip

MODULE
	COUNTERTOP
BRACKET
CLIP	89 mm
	CLAMPING
	SCREW

Installation brackets

11