10
MODULE IN S TA L L AT I O N
Toprevent pollutio n from entering the controls
area, attachthe foam strip to the underside of
the module frame. Refer to the illustration
below.
Gently lower the grill module into the cut-out
area in the countertop and center. Check that
the front edge of module is parallel to the front
edge of the countertop. Check that all required
clearances are met.
Toattach the brackets to the sides of the
module, insert the clip into the rectangular
punchout in the pan, and push down. Install
the clamping screw into the bracket and
tighten until the screw contacts the underside
of the countertop. Do not overtighten screws.
Refer to the illustration below.
IMPORTANT NOTE:
Do not use caulk or
silicone to seal the module to the countertop.
The unit must be readily removable for service.
BE F O R E OPERATING
Read the entire Wolf Grill ModuleUse & Care
Information included with the module. Impor-
tant safety,service and warranty information is
contained within the book.
Thoroughly clean the grilling grate, grease
deflection plates and grease collection pan
with mild soap and water before use.
Foamstrip Installation brackets
IN S TA L L AT I O N INSTRUCTIONS