WOL F GRI LL MODULE
INS TA LLATIO N RE QU IREMENTS
IMPORTANT NOTE: Save these Installation Instructions for the local inspector’s use.
Please read the entire Installation
Instructions prior to installation.
This installation must be completed by a qualified technician.
Installer: please retain these instructions for local inspector’s reference, then leave them with the homeowner.
Homeowner: please read and keep
these instructions for future reference and be sure to read the entire Use & Care Information prior to use.
IMPORTANT NOTE: This appliance must be installed in accordance with local codes. The correct voltage, frequency and amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly sized circuit breaker or time delay fuse. The proper voltage, frequency, and amperage ratings are listed on the product rating plate.
Record the model and serial numbers before installing the grill module. Both numbers are listed on the product rating plate located on the underside of the module. Refer to the illustration below.
BE FORE YOU ST AR T
IMPORTANT NOTE: Installation and service must be performed by a qualified installer or service agency.
Installation of the grill module must meet the minimum clearance requirements for safe operation. Refer to Site Preparation on page 6.
If the grill module is to be used with any combination of additional cooktop units or modules, refer to Multiple Cooktop Installa- tion on page 8.
Electrical installation must be adequate and in compliance with all local codes and ordinances. Electrical ground is required, refer to Electrical Requirements on page 9.
IMPORTANT NOTE: A ventilation hood is recommended (but not required) for use with the Wolf electric grill module.
This module is intended for indoor use.
Model ICBIG15/S
Model Number
ICBIG15/S
Serial Number
Location of rating |
plate under module |
Rating plate location
5
