Wolf Appliance Company PW482210R, PW482718R manual G N At U R E P O L I S H, Cleaning a N D Care

S I G N AT U R E P O L I S H

Signature Polish is available from Signature Limited Laboratory,

W O L F PRO VENTILATION HOOD U S E & C A R E

CLEANING A N D CARE
Most surfaces of your Wolf Pro hood are		D E C O R AT I V E R A I L
stainless steel. Although resistant to most			Clean the decorative hood rail using warm
stains, it is not totally impervious to damage.
			soapy water. Then hand dry with a clean,
G E N E R A L C L E A N I N G			soft cloth.
			It is not necessary to remove the decorative
	Salt and some cooking liquids may pit and		rail from the hood assembly. It should be
	stain the surface. Always remove any film		cleaned in place.
	or spills immediately.		Be careful not to pull or hang on the bar, as
	Avoid using abrasive cleaners. They will		this could damage the hood assembly.
	permanently scratch the surface.

P. O. Box 13436, Dayton, Ohio 45413-0436, or call 877-376-5474 (toll free).

Do not use steel wool pads.

Be careful not to soak the rotary switches. Although they are sealed, excessive moisture may cause damage to the controls.

A spray degreaser will remove fingerprints and greasy spatters. Spray on a cloth and wipe surface. Buff dry immediately to avoid streaking.

Use white vinegar and water to remove hard water stains.

Use a clean cloth or sponge, wipe with warm water and mild detergent. Rinse and dry immediately.

Apply a protective polish like Signature Polish (see side note) to the surface to maintain luster and protect against food stains. Apply the polish following the same grain direction as the finish.

S TA I N L E S S S T E E L F I N I S H

Use a soft, nonabrasive stainless steel cleaner like Signature Polish (see side note) and apply with a soft lint-free cloth. To bring out the natural luster, lightly wipe the surface with a water-dampened microfiber cloth, followed with a dry microfiber cloth. All work should follow the same grain direction as the finish. Best results are obtained by keeping the cloth in continuous contact with the metal.

Under no circumstances should you use a metallic or highly abrasive cleaner or cloth, as this will damage the finish.

16