Wolfgang Puck BECR0010 manual Before Your First Use, Know Your Espresso Maker, Control Panel

Know Your Espresso Maker

Lid to Removable	Water Level	Removable
Water Container	Window
		Water
	Steam	Container
	Nozzle

Removable
Cup Warmer	One- and
	Two-Cup
	Filters

Measuring

Spoon

and

Tamper

	Removable
	Drip Tray
Overflow	Filter
Grid	Holder

Control Panel

On/Off Indicator	On/Off Switch
Light
	Steam/Espresso
3-Way Selector	Selector
Knob
	Thermostat Light

Before Your First Use

Read all instructions. Carefully unpack espresso maker and remove all packaging materials. Place your espresso maker on a level surface such as a countertop or table.

Wipe the exterior surfaces with a clean, damp cloth or sponge and dry with another cloth. Wash all accessories in hot, sudsy water. Rinse and dry thoroughly. Caution: Do not immerse the cord in water or any other liquid.

We recommend preparing several cups of water (without any coffee) to rinse the system thoroughly and remove any dust or small particles. Follow the steps below before initial use and after a long period of non-use.

1.Be sure that the selector knob is in the vertical, or stand-by, position. Plug the cord into a 120 volt, AC outlet. Press the On/Off switch to turn on the machine. Both lights will illuminate. Preheat 3 minutes before initial use.

2.Remove the water container and the filter holder. Fill the water container with fresh, cold water and insert into the machine. When inserted correctly, push the water container slightly down to open the valve. The water container lid will close properly only if the container is properly inserted and the valve is opened.

3.Insert one of the filters without coffee into the filter holder. When inserting the filter holder, the handle points approximately 45 degrees to the left. When properly aligned, pull the filter holder to the right. The filter holder is inserted properly when the handle points to the front of the machine or slightly to the right.

Caution: If you do not insert a filter into the filter holder, it is not possible to tighten the filter holder. The filter holder could then come out of the machine while hot water runs through it.

4.Place a large cup underneath the filter holder. When the thermostat light goes out, turn the selector knob to the right and the steam/espresso button to the espresso position. Hot water will run through the filter holder into the cup. The pump will make noise. Stay with the machine as long as water runs through it. When the cup is full, turn the selector knob to the vertical, or stand-by, position. This will stop the pump. Empty and replace the cup and repeat process until the water container is empty.

Caution: When the water container is empty and the pump is running, the noise will increase considerably. Do not let the pump run with an empty water container. This can damage the pump permanently.

4 5