Install Rear Offset Link Arms
1.Loosen nut (51) and bolt (55) at rear frame lug and attach rear offset link arm (14) as shown in Figure 24. (Do not use wheel tube bolt.)
2.Repeat for opposite side.
3.Do not tighten at this time.
55
14
51
14.Rear offset link arm
51.Nut, flanged lock 1/2 NC
55.1/2 NC x
Figure 24. Right Rear Offset Link Installed
Install Top Link
1.Insert cap screw (54) through
2.Tighten hardware on rear frame lug and offset link.
14 |
|
| 51 |
|
|
| |
|
|
| 16 |
54 |
|
|
|
| 13 | 15 | |
|
| ||
13. |
| ||
14. | Rear offset link arms |
| |
15. | Link, |
| |
16. | Sleeve, .62 x .84 x 2.75 | ||
51. | Nut,flanged lock 1/2 NC | ||
54. | Screw, HHCS 1/2 NC x | ||
|
|
| CM757 |
Figure 25. Top Link Assembled
Install Driveshaft
1.Slide QD yoke of driveshaft assembly onto gearbox shaft. Make sure QD yoke pin is seated securely in groove of gearbox shaft.
2.Attach shield
Fill Gearbox
1.Make sure vent plug hole is clear. Fill gearbox half- full with high quality gear oil that has a viscosity index of 80W or 90W and an API service rating of
2.Fill gearbox until oil runs out the side plug on gearbox.
3.Pour in one pint of gear lube, wait five minutes and add additional gear lube until it just comes out of side hole.
4.Allow an additional five minutes for the lube to flow through bearings, then check to make sure oil level is at bottom of side hole. Replace side plug. Install vent plug.
IMPORTANT
■Gearbox is not filled at the factory. Prior to delivery, make sure each gearbox is filled
Install Chain Shielding (Optional)
3.Shield, chain plate
14.Bolt, carriage 3/8 NC x 1
15.Nut, flanged lock 3/8 NC
15
14
3
CM768
Figure 26. Chain Shielding Installed
(RD60 & RD72 Only)
28Assembly
(Rev. 1/13/2006) MAN0260 (8/6/2004)
