-2-
D3038 Remote Dust Collector Switch
Grounding Prong
Neutral Hot
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
110V
Figure 4. NEMA 5-15 plug & receptacle.
DO NOT modify the provided plug or
use an adapter if the plug w ill not fit
your receptacle. This is an indication
that your power supply circuit does
NOT meet the requirements for the
machine; have an electrician install
the correct power supply circuit. If
the machine must be reconnected for
use on a different type of electric
circuit, the reconnection should be
made by a qualified electrician or
service personnel; after reconnection,
the machine must comply with all local
codes and ordinances.
4. Plug the receiver power cord into a 5-15 receptacle,
then plug the dust collector cord into the receiver
unit.
5. If the batteries are not installed in the remote
control transmitters, install them as described on
Page 3.
2. Attach the mounting bracket in the chosen location
using the included screws, as shown in Figure 3. If
you are mounting the bracket to the dust collector
frame, you may have to use alternative mounting
hardware.
3. Hook the receiver unit onto the mounting bracket.
Figure 3. Mounting.
Wall
Mounting
Bracket
Side
View
Screws
Reciever
Unit
Only connect the Model D3038 to a 110V circuit with a
NEMA 5-15 receptacle. DO NOT connect a dust collec-
tor with a motor larger than 1
1⁄2 HP. Failure to follow
these warnings will void the warranty and could cause
damage to the remote switch and the dust collector.
Installation
1. Identify a mounting location for the receiver unit
that allows the power cord to reach an appropriate
outlet and the dust collector power to be plugged
into the receiver outlet.
Note: You may choose to attach the receiver unit
directly to your dust collector. If so, mount it to a
portion of the frame that will not compromise the
function or strength of the dust collector.