-3-
D3038 Remote Dust Collector Switch
Figure 6. Battery installation/
replacement.
Figure 5. ON/OFF Switch location.
ON/OFF Switch
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Unit will not turn on. 1. Remote is out of range.
2. Signal is obstructed.
3. Remote is not turned ON.
4. Dust collector is turned OFF
5. Receiver circuit breaker has
tripped.
6. Wall circuit breaker has tripped.
7. Remote battery is weak/dead.
8. Connected to a machine with a
magnetic switch.
9. Dust collector is at fault.
10. Remote control transmitter is at
fault.
11. Receiver unit is at fault.
1. Move remote closer to receiver unit.
2. Remove obstructions to provide direct line of sight
between remote and receiver.
3. Turn ON remote control transmitter.
4. Turn ON dust collector.
5. Allow unit to cool, then press the button on the
bottom of the receiver unit to reset breaker.
6. Reset wall circuit breaker. Check that breaker is in
good condition and circuit is properly sized for the
dust collector in use.
7. Replace weak/dead battery.
8. Only use this unit on machines with standard ON/
OFF toggle switches.
9. Refer to dust collector manufacturer's
documentation for troubleshooting.
10. Check/use second remote.
11. Replace unit.
TroubleshootingReplacing Batteries
1. Remove the two screws from the back of the remote
control transmitter.
2. Remove the back of the remote control transmitter,
as shown in Figure 6.
3. Remove the existing battery, then install a new 9V
battery.
4. Replace the back of the remote transmitter and
secure it with the two screws removed in Step 1.
6. Turn the remote control transmitters ON with
the ON/OFF switch shown in Figure 5. The LED
indicators will light to show the transmitters are
working.
— If the LEDs don't light, remove the protective
covering from the batteries. See Replacing
Batteries below to access the batteries.
Note: To conserve battery life in the remote control
transmitters, only turn them on when they are
needed for use.
7. Turn the switch on the dust collector unit to the
ON position. Test the function of the remote dust
collector switch by pressing the ON and OFF buttons
on each remote.
Tip: During long-term storage, remove the batteries from
the remote control transmitters to prevent damage from
battery leakage or corrosion.