Woodstock D3206 manual

Drill Guide Kit

Made with the highest quality materials and manufactured to

exacting specifications for top performance.

Visit our website: shopfox.biz

Manufactured in Taiwan

for Woodstock International, Inc.

512703961

STEELEX PLUS® IS a rEgISTErEd TradEMark of

D3206

drILL gUIdE kIT

Wear aNSI approved safety glasses

CAUTION

• Secure workpiece with clamps or vise before drilling.

• always wear aNSI approved safety glasses when drilling.

INFORMATION

• for drilling spheres, center the concave recess under the drill

guide on the sphere.

• for drilling cylinders and corner edges, use the V-groove under the

drill guide.

• To drill the center line of an edge, slide two small nails into the

holes the drill guide. Straddle the edge with the nails and twist the

drill guide so the nails are stopped on the front and back face of

the workpiece.

INSTRUCTIONS

1. Locate and mark the center of the hole to be drilled with an awl or

center punch.

2. Insert the 3⁄16" bushing into the drill guide and insert the

Centerpunch/Locator into the bushing.

3. Place the drill guide over the workpiece and center the Locator

over the center mark.

4. Without moving the drill guide, remove the Locator and 3⁄16"

bushing from the drill guide.

5. Insert the desired size drill bushing with the large end up into the

drill guide.

6. Insert the appropriate size drill bit into the drill bushing and drill the

hole.