Figure 12. Tool rest installed on lathe bed.
Before installing a tool rest, decide which
one will be best for your application. Unless
workpiece clearance is an issue, install the
larger tool rest to give yourself more room to
work.
To install the tool rest, do these steps:
1. Insert the tool rest into the tool holder as
shown in Figure 12.
2. Lock the tool rest in place with the tool rest
lock.
Tool Rest
ASSEMBLY
-14-
Figure 11. Tightening face plate to
headstock spindle.
The face plate can be installed only if the spur
center has been removed from the headstock
spindle.
To install the face plate, do these steps:
1. UNPLUG THE LATHE!
2. Thread the face plate onto the headstock
spindle.
3. Tighten the face plate by placing a wrench
on the spindle flats and inserting the knock-
out tool into the spindle shoulder to hold
it in position during tightening. See Figure
11.
Note: Reverse steps 2-3 to remove the face
plate.
Tool Rest
Lock
UNPLUG- the power cord
before you do any assem-
bly or adjustment tasks!
Otherwise, serious per-
sonal injury to you or oth-
ers may occur!
Face Plate