Woodstock W1775 Replacing Piston Rings, To replace a piston and O-rings, do these steps

Model W1775 Nailer/Stapler Kit

Replacing Piston and

O-Rings

6.Open the nose cover as if to clear a jammed nail/staple.

Under heavy use, a piston or piston shaft may wear out. Replacement is quick and easy. Contact your authorized Shop Fox dealer to obtain the Piston Repair Kit (part number X1775001).

Always disconnect air from nailer/ stapler whenever servicing! During maintenance, a nailer/stapler con- nected to air may fire accidentally, causing serious personal injury!

To replace a piston and O-rings, do these steps:

1.DISCONNECT NAILER/STAPLER FROM THE AIR SUPPLY!

2.Remove all nails/staples from the magazine cartridge, and clean the exterior of the nailer.

3.Remove the four cap screws on the back of the nailer/stapler, near the exhaust port.

4.Remove the cap.

5.The top of the piston should now be visible inside the cylinder, which is housed in the head of the nailer/sta- pler.

7.Watch the discharge area and push the top of the piston with your finger. You will see the piston shaft slide down the discharge area.

8.Taking care not to scratch or dent the nailer parts, use a wooden dowel or similarly shaped tool to push the piston shaft back inside the nailer/stapler until you can grip the piston head and remove it from the cylinder. Clean and inspect the parts for cracks, wear, or burrs.

9.Place a new O-ring on the new piston and apply a thin film of the nailer/ stapler lubricating oil on the O-ring.

10.Insert the new piston in the cylinder. Make sure that the grooves on the piston shaft line up with those on the guide at the bottom of the cylinder. The new piston should easily slide into the cylinder. DO NOT force the piston into the cylinder! If the piston is not easily inserted, double-check the alignment of the piston shaft with the grooves on the guide.

11.After the piston is inserted correctly, close the magazine. Replace the rear cap assembly and tighten the four cap screws.

12.For more assistance, or to install a complete O-ring set, refer to the appropriate breakdown diagram in the back of this manual for component locations.

-11-