Woodstock W1815 manual Disc Sanding, To use the sanding disc, do these steps

Model W1815 (Mfg. Since 10/10)

Disc Sanding

The Model W1815 uses dual-axis miter slot design for increased versatility of workpiece control.

Always keep the workpiece on the side of the wheel that is rotating down toward the table. This will keep the workpiece from flying out of your hands if kickback occurs.

To reduce the risk of your fingers getting trapped between the work table and sanding disc, make sure the table is approximately 3⁄16" away from the sanding disc.

To use the sanding disc, do these steps:

1.DISCONNECT SANDER FROM POWER!

2.Set the angle of the table and miter gauge for your operation.

3.Connect the sander to power, turn it ON, and allow it to reach full speed.

4.Place the workpiece on the work table and firmly against the miter gauge.

5.With light, but firm pressure, push the workpieece into the down-spin side of the rotating disc. See Figures 13—16for examples of disc sanding.

Note: To prevent burning the workpiece and overloading the sanding disc, move the workpiece slowly back and forth from the left side of the sanding disc to the center.

Figure 13. Example of Y-axis sanding.

Figure 14. Example of X-axis sanding.

Figure 15. Angle sanding.

OPERATIONS

Figure 16. Sanding with table angled.

-19-